This tutorial shows you how to make a paper battery holder for coin cell batteries CR and CR Scroll to the bottom of this page for the video tutorial. Take one of the copper tape pieces and peel off the paper backing. See below for directions on how to fold the copper tape.

How-To: Free DIY battery holders | Make:

Leave the excess copper tape hanging off the battery holder. Flip the template over. Peel the paper backing off the other piece of copper tape and match the piece of copper with the vertical printed line. Stick the copper down over the printed line and leave the excess copper dangling off the battery holder. Flip the template over and fold the vertical flap along the top dotted line, so that the copper tape is on the outside.

Then fold again along the next dotted line, as if you are rolling the flap down.

This creates a springy tab which ensures good contact with the battery. Finally, fold the entire flap once more along the third dotted line, so that the edge is even with the edge of the battery holder.

Flip the battery holder over and fold the extra bit of the tap around the si puo diventare ricchi con il forex of the holder. This horizontal band holds the contacts to the battery, so make sure the band is tight to ensure a snug fit.

The easiest way to add an LED is to take tape the LED directly onto the copper tape leads of your battery holder. Once it is matched up, simply tape down the Wot best tier 6 premium money maker with regular transparent.

If your How to make a battery holder out of paper is oriented incorrectly, it wont light up. In this case, simply peel it off and tape it back down the in the proper orientation. To turn the battery holder ontuck the top flat between the outside band and the negative lead. This ensures a tight contact between the leads and the battery. To turn the battery holder offtuck the top flat between the negative lead and the battery.

This isolates the battery from the negative lead, ensuring that the circuit is off without needing to remove the battery from the circuit. Your email address will not be published.

Paper battery holder tutorial | The Fine Art of Electronics {under construction}

You may use these HTML tags and attributes: Paper battery holder tutorial 1 Reply. Materials and Tools battery holder template printed on cardstock download PDF here conductive copper tape available at digikey and sparkfun regular tape e. Folding to make the copper tape turn: At the turn, fold the tape back over itself so that the sticky side is up. Flip the tape over, while introducing the angle and flatten the tape.

This completes the turn.

How to Make a Paper Battery Holder | Coins, Copper and Template

Tape this tab down with regular tape. Adding an LED The easiest way to add an LED is to take tape the LED directly onto the copper tape leads of your battery holder.

This ensures a tight contact between the leads and the battery To turn the battery holder offtuck the top flat between the negative lead and the battery. Kit-of-No-Parts Leave a Reply Cancel reply Your email address will not be published. Proudly powered by WordPress.